|
Top 10 Reasons Bathtub Refinishing Work Do Not Last
1.
Most refinishers use the wrong etching products or none at all.
Answer:
We use micro etching systems for stronger bondablity.
2. Most refinishers do not clean bathtub surfaces correctly.
Answer:
We use special high-grade cleaning solvents.
3. Most refinishers do not remove ceramic etching-scale during
preparation.
Answer: We commercially de-scale all bathtub surfaces after etching.
4.
Most refinishers do not recognize acid resistant surfaces.
Answer: We use a special pre-prime adhesive on all acid-resistant surfaces.
5. Most refinishers use the wrong bonding agent on iron-oxide finishes.
Answer: We use a highly formulated seal-coat to help bond
iron-oxide surfaces.
6. Most refinishers do not use the proper adhesive to prepare for
refinishing.
Answer: We use low build ceramic-substrate primer adhesives.
7. Most refinishers over or under dry their top coat finishes.
Answer: We use high quality adjustable air flow drying systems.
8. Most refinishers damage the polymers in the coating by using poor
solvent.
Answer: We use ultra-pure top coat reducer for our finishes.
9. Most refinishers use home-grown off the counter inferior systems.
Answer: ShurBond® Refinishing Systems are designed for bathroom
refinishing.
10. Most refinishers do not mix their top coat properly.
Answer: ShurBond® Coating Systems are regulated by the
manufacture specification and solids are carefully montiored for
quality control.
Note: Many over the counter systems(home-grown) that our competitors are selling really are not designed for hotel or residential bathroom & kitchen refinishing work. Many of these companies destroy the natural qualities of their products by over drying & using excessive amounts of solvent & fillers to speed the drying times. One huge problem with the bathtub refinishing industry is products that are being marketed as fast dry systems. They become brittle and are not generally flexible systems and will cause cracking.
|
